Loading ...
Loading ...
Loading ...
2.14.4 SHROUD
1. Remove the fan. (Refer to section 2.14.3)
2. Remove the 2 screws which fasten the shroud.
3. Remove the shroud. (See Figure 64)
4. Re-install the component by referring to the
removal procedure, above.
Figure 64
2.15 ELECTRICAL PARTS
2.15.1 MOTOR
1. Remove the cabinet. (Refer to section 2.13.2)
2. Remove the cover control and disconnect a wire
housing in control box. (Refer to section 2.13.3)
3. Remove the blower. (Refer to section 2.14.2)
4. Remove the fan. (Refer to section 2.14.3)
5. Remove the 4 screws which fasten the motor.
(See Figure 65)
6. Remove the motor.
7. Re-install the components by referring to the
removal procedure, above.
Figure 65
2.15.2 COMPRESSOR
1. Remove the cabinet. (Refer to section2.13.2)
2. Discharge the refrigerant system using FreonTM
Recovery System.
If there is no valve to attach the recovery system,
install one (such as a watco a-1) before venting
the FreonTM. Leave the valve in place after
servicing the system.
3. Disconnect the 3 leads from the compressor.
4. After purging the unit completely, unbrace the suc-
tion and discharge tubes at the compressor con-
nections.
5. Remove the 3 nuts and the 3 washers which fas-
ten the compressor.
6. Remove the compressor. (See Figure 66)
7. Re-instill the components by referring to the
removal procedure, above.
Figure 66
--27--
Loading ...
Loading ...
Loading ...