Loading ...
Loading ...
Loading ...
Things to Consider Before You Connect
Protect Against Power Surges
° Connect all components before you plug any of their power coixls into the wall outlet.
° Turn off the TV and/or component before you connect or disconnect any cables.
° Make sure all antennas and cables aix, properly grounded. Refer to the Important Safety
Instructions on page 1.
Protect Components from Overheating
• Don't block ventilation hok's on any of the components. Arrange the components so that air
can circulate freely.
• Don't stack components.
° If you place components in a stand, make sure you allow adequate ventilation.
• If you connect an audio receiver or amplifier, place it on the top shelf so the heated air from it
won't flow around other components.
Position Cables Properly to Avoid Audio Interference
• Insert each cable firmly into the designated jack.
• If you place components above the T\,', route :ill cables down the side of the back of the T\.'
instead of straight down the re\Idle of the T\/.
• If your antenn:_ uses 300-ohm twin lead cables, do not coil the cables. Also, keep the twin
lead cables away from audio'video cables.
Important Stand and Base Safety Information
Choose th{' location for your TV carefully. Plat{' the TV on a starK] or base that is of adequate size
:rod strength to prev{'nt the T\/from being :tccider_tally tipped over, pushed oft', or pulled off. This
could cause personal injury :rod/or damage the T\.'. Refer to the Important Safety Instructions on
page 1.
Use Indirect Light
l)on't place the T\/;x h{'re sunlight or room lighting will Ix' directed toward the screen. 1 Ts{, soft or
indirect lighting.
Cables Needed to Connect Components to Your TV
The pictures below show the cables needed for the conn(,cti{}ns repr{,s{,r]ted in this book. The
next two pages ex[)l:/ir_ the inputs :rod outputs your HI)T\, or'furs for connecting components.
Audio/Video Coaxial cable S-Video cable Component Video
cables (Y,Pb,Pr) cables
DVI-HDTV Cable
8 Chapter I
Loading ...
Loading ...
Loading ...