Loading ...
Loading ...
Loading ...
Owner’s Guide & Installation Instructions
43 / English
Troubleshooting
There is water coming
from the bottom of the
washer.
Inlet hose connections may be
leaking.
Be sure the strainers and rubber seals
of the water inlet hoses are solid and
securely fitted.
End of the drain hose may be loosely
inserted into the waste pipe or sink.
Tightly attach the drain hose to the
waste pipe or sink (See “Installation
Instructions, Drainage”).
House drain may be clogged.
If the house drain pipes are clogged, call
a plumber for assistance.
Filter cap of the drain pump may not
be properly fitted.
Make sure that the pump filter cap is
tightly closed.
Hose connections inside the washer
may be leaking.
Internal hose connections (e.g.
dispenser hoses, drain system) should
be checked by a service technician.
Washer fills with water
when a process is
cancelled.
There may be hot water inside
washer.
For safety reasons, water should be
cycled in and out a couple times.
Time delay function does
not work.
Door may not be closed properly. Close the loading door.
The door will not open.
Water level might be above the
lower level of the door.
Run “Drain” , “Spin” or “Drain&Spin”
program.
Washer might be heating up the
water or it may be at the spinning
cycle.
Wait until the process is over.
Due to electrical safety mechanism,
the door can only be opened a few
minutes after the program has
stopped.
Wait until the process is over.
If the door can not be opened after
minimum ten minutes the program
has stopped , on/off buton should be
placed to off position.
In this situation, call the qualified
service technician.
The door will not lock/
door expression is on LCD
Door is not properly closed/Door
hinge is not aligned with lock
switch.
Push the loading door firmly shut until
you hear it lock into space
Loading ...
Loading ...
Loading ...