WM77120 User Manual

Loading ...

Owner’s Guide & Installation Instructions

15 / English

Installation Instructions

WARNING

Ò Be sure that there are rubber seals located on the hose connections. These

seals and adjustable bolts ensure a safe connection without leaking. After the

water connection is done, turn on both water faucets slowly and completely

to check any water leaks.

Ò Be sure that water supply hoses are not crushed and they have no kinking,

bulges or cuts before the water connection.

The water pressure must be between 15-145 psi (1-10 bar) for the proper operation of this washer.

1 bar corresponds to more than 2.1 US gallons (8 liters) per minute flow rate with a fully open faucet.

Water inlet hoses and valves should withstand a water pressure of 145 psi (10 bar) at maximum. If the

pressure is higher than 145 psi, a pressure-reducing valve must be installed before the water inlet.

If the water pressure is lower than 15 psi (1 bar), water fill time may extend or water inlet valve may

shut off completely.

• Hotwatersupplytemperaturemustnotexceed140˚F(60˚C).(Ideally120˚F(48˚C))

• Donotconnectthewashertoanunpressurizedwaterboilersincewaterpressuremaynotbe

adequate for proper operation.

• Donotremovethefilterslocatedonthewatersupplyhoses(onfaucet/hoseandhose/inletvalve

connections).

• Alwaysusegenuine“Blomberg”watersupplyhoseswhenconnectingwiththiswasher.Oldor

worn-out hoses must not be reused. It is not advised to extend inlet or drain hoses, if necessary

consult your dealer or technical service about hose extensions.

• Hotandcoldwaterfaucetsmustalwaysbeeasilyaccessibletotheuser.

• Attheendofawashingday,turnoffwaterfaucetstopreventanyleakageorwaterdamagethat

may occur due to a faulty condition of the appliance.

• Checktheapplianceandinlethoseconnectionsforwaterleakageaftereachuse.Ifthereis

leakage, turn off the appliance and water faucets and call service.

• Checkthewaterinletanddrainhoseconnectionsregularlyforanyleakage.Hosesshouldbe

replaced every 5 years.

• Ifthereisnohotwatersupply,hotwatervalvemustbeconnectedtoacoldwaterfaucet

nevertheless. Both water valves should be connected to water supply for proper operation of your

washer.

Drainage

WARNING

Ò Drain hose should not be bent. Be sure that there are no kinks or cuts on it.

Ò Drain hose outlet must not contact the drained water.

Drain hose may be connected into a sink, into the drain of a sink, to a standpipe and floor drain.

• Whenconnectingintoasink,thedrainhoseshouldbeplacedattheedgeofthesinkandsecured

with the hose guide supplied by the manufacturer. Additionally, the guided hose may be tied to the

water faucet with a strap for extra security.

• Drainhosemaybeconnectedintothedrainofasink.Besurethattheconnectionissafeandnot

leaking. An additional clip etc can be used for safe connection.

• Drainhosemayalsobeconnectedtoaminimum1.26in(32mm)diameterstandpipe.

Loading ...

User Manual - Page 15