WM77120 User Manual

Loading ...

14 / English

Front-Loading Automatic Washer

Installation Instructions

Power supply and circuit

Connect the clothes washer to the junction box supplied. Junction box must be connected to an

earthed outlet protected by a fuse of suitable capacity.

Important:

• Mainsconnectionshouldcomplywithnationalregulations.

• Thewiringfortheelectricaloutletcircuitmustbesufficienttomeettheappliancerequirements.

Use of a Groud Fault Circuit Interrupter (GFCI) is recommended.

• Thevoltageandmaximumtotalcurrent arespecifiedinthesection“Specifications”.

• Theappliancemustnotbedirectlyconnectedtothemainsincaseofabsenceofjunctionbox.

• Connectionviaextensioncordsormulti-plugsshouldnotbemade.

WARNING

Ò A damaged power cable must be replaced by a qualified electrician.

Ò Theappliancemustnotbeoperatedunlessitisrepaired!Thereistheriskof

electricshock!

15 Amp. Fuse or circuit breaker, 208-240 volt, 60 Hz, grounded, alternating current

Properlygrounded3-prongreceptacleandjunctionboxtobelocatedsothepowersupplycordsare

accessible when the washer is in installed position.

Water Supply Connection

Your washer comes with both cold and hot water connections. Connect the blue marked cold water

supply hose to the cold water inlet valve/faucet and the red marked hot water intake hose to the hot

water inlet valve/faucet. Screw the connecting bolts by hand and tighten the connection properly using

a plier. Over tightening may cause damage on bolted connection.

WARNING

Ò Be sure that the water connection of this washer is handled by a qualified

service technician or a plumber.

Thewasherhastwobolted½’’watersupplyhosesand¾’’femalehoseconnectionsthatcanbe

connectedto¾’’hotandcoldwaterfaucets.

Loading ...

User Manual - Page 14