Loading ...
Loading ...
Loading ...
67
6. Maintenance
To clean the ar-lter:
Vacuum the lter-through the lter cover.
To replace the lter (sponge):
1. Remove the filter cover (2 locations) by pushing up on the tab of the cover.
2. Replace two filters.
This section describes the simple maintenance procedures you should follow to clean the lter and replace the lamp.
❶
Cleaning or Replacing the Filter
The air-lter sponge keeps dust and dirt from getting inside the projector and should be frequently cleaned. If the
lter is dirty or clogged, your projector may overheat.
NOTE: The message for filter cleaning will be displayed for one minute after the projector is turned on or off.
To cancel the message, press any button on the projector cabinet or the remote control.
CAUTION
• Turn off the projector, turn off the main power switch and unplug the projector before replacing the lter.
• Only clean the outside of the lter cover with a vacuum cleaner.
• Do not attempt to operate the projector without the lter cover.
NOTE: When turning over the projector, slowly place it on a soft cloth so as not to scratch the cabinet.
Loading ...
Loading ...
Loading ...