Loading ...
Loading ...
Loading ...
BLANK
MENU
POWER
INPUT
IMAGE
ASPECT
INFO.
AUTO PC
BACK
BLANK
MENU
POWER
INPUT
IMAGE
ASPECT
INFO.
AUTO PC
BACK
. Projectng an Image (Basc Operaton)
Note on Startup screen (Menu Language Select screen)
When you rst turn on the projector, you will get the Startup menu. This menu gives you the opportunity to select
one of the 21 menu languages.
To select a menu language, follow these steps:
1. Use the or button to select one of the 21
languages for the menu.
2. Press the OK button to execute the selection.
After this has been done, you can proceed to the menu op-
eration.
If you want, you can select the menu language later. See
[Language] on pages 47 and 58.
NOTE: Immediately after turning on the projector, screen flicker may occur. This is normal. Wait 3 to 5 minutes until the lamp
lighting is stabilized.
NOTE: If you turn on the projector immediately after the lamp is turned off or when the temperature is high, the fans runs with-
out displaying an image for some time and then the projector will display the image.
When the Lamp mode is set to Quiet, the LAMP indicator will light green.
If one of the following things happens, the projector will not turn on.
• If the internal temperature of the projector is too high, the projector will not turn on to protect the internal system.
Please wait for the projector's internal components to cool down.
• When the lamp reaches its end of usable life, the projector will not turn on. If this happens, replace the lamp.
• If the lamp fails to light, and if the STATUS indicator ashes on and off in a cycle of six times, wait a full minute
and then turn on the power.
NOTE: Turning the Main Power Switch Off then Back On
Allow a minimum of 1 second between turning off the main power switch and turning it back on again.
The same will be applied when a power strip equipped with a switch and a breaker is used.
Failing to do so could result in no power to the projector. (There will be no stand-by LED)
Should this happen, unplug the power cord and plug it in again. Turn on the main power switch.
CAUTION:
The projector cannot be turned off for 60 seconds after the lamp is turned on and while the POWER indicator
is blinking green. Doing so could cause premature lamp failure.
Loading ...
Loading ...
Loading ...