Loading ...
Loading ...
Loading ...
(214,1)
北米Model "A1370BE-B" EDITED: 2019/ 11/ 12
Refer to “Windshield washer
fluid” F11-29.
. Do not clean the blade rubbers
with gasoline or a solvent, such
as paint thinner or benzine. This
will cause deterioration of the
blade rubbers.
NOTE
. The windshield wiper motor is pro-
tected against overloads by a circuit
breaker. If the motor operates continu-
ously under an unusually heavy load,
the circuit breaker may trip to stop the
motor temporarily. If this happens, park
your vehicle in a safe place, turn off the
wiper switch, and wait for approxi-
mately 10 minutes. The circuit breaker
will reset itself, and the wipers will
again operate normally.
. Clean your blade rubbers and win-
dow glass periodically with a washer
solution to prevent streaking, and to
remove accumulations of road salt or
road film. Operate the windshield
washer for at least 1 second so that
washer solution will be sprinkled all
over the windshield or rear window.
. Grease, wax, insects or other mate-
rial on the windshield or the blade
rubbers results in jerky wiper operation
and streaking on the glass. If you
cannot remove those streaks after
operating the washer or if the wiper
operation is jerky, clean the outer sur-
face of the windshield or rear window
and the blade rubbers using a sponge
or soft cloth with a neutral detergent or
mild-abrasive cleaner. After cleaning,
rinse the window glass and blade
rubbers with clean water. The glass is
clean if no beads form on the glass
when you rinse with water.
. If you cannot eliminate the streaking
even after following this procedure,
replace the blade rubbers with new
ones. For replacement instructions,
refer to “Replacement of wiper blades”
F11-30.
& Windshield wiper and washer
switches
S03AM01
The wiper operates only when the ignition
switch is in the “ON” or “ACC” position.
! Operating the wiper lever
S03AM0106
: Mist operation (for a single wipe)
: Off
: Intermittent operation
: Low speed operation
:
High speed operation
For a single wipe of the wipers, push the
lever up. The wipers operate until you
release the lever.
Instruments and controls/Wiper and washer
3-76
Loading ...
Loading ...
Loading ...