Loading ...
Loading ...
Loading ...
(131,1)
北米Model "A1370BE-B" EDITED: 2019/ 11/ 12
ignition switch from the “LOCK”/“OFF” to
the “ON” position with a registered key/
access key fob.
NOTE
For models with “keyless access with
push-button start system”, if the ac-
cess key fob battery is discharged,
perform the procedure described in
“Switching power status” F9-18. In
such a case, replace the battery im-
mediately. Refer to “Replacing battery
of access key fob” F11-46.
& Alarm system setting
S02AF11
To change the setting of your vehicle’s
alarm system for activation or deactiva-
tion, do the following.
1. Disarm the alarm system. Refer to
“Disarming the system” F2-26.
2. Sit in the driver’s seat and shut all
doors, rear gate and engine hood.
3. Turn the ignition switch to the “ON”
position.
4. Hold down “
” of the driver’s power
door locking switch, open the driver’s door
within the following 1 second, and wait 10
seconds without releasing the switch. The
setting will then be changed as follows.
. Type A combination meter
Setting
status
Combination
meter display
Horn
Activate ALon Once
Deactivate ALoF
Twice
. Type B combination meter
Setting
status
Combination
meter display
Horn
Activate AL ON Once
Deactivate AL OFF
Twice
NOTE
You may have the above setting change
done by your SUBARU dealer.
& If you have accidentally trig-
gered the alarm system
S02AF03
! To stop the alarm
S02AF0301
Do any of the following operations:
. Press any button on the access key fob/
remote transmitter.
. Turn the ignition switch to the “ON”
position (models without “keyless access
with push-button start system”).
. Turn the push-button ignition to the
“ACC” position (models with “keyless
access with push-button start system”).
NOTE
Only registered keys will stop the
alarm. If the immobilizer transponder
is not registered, the alarm will not
stop.
& Valet mode
S02AF06
When you choose the valet mode, the
alarm system does not operate. In valet
mode, the remote transmitter is used only
for locking and unlocking the doors and
rear gate and panic activation.
To enter the valet mode, change the
setting of your vehicle’s alarm system for
deactivation mode. Refer to “Alarm system
setting” F2-27. The security indicator light
will continue to flash once every 3 seconds
indicating that the system is in the valet
mode.
To exit valet mode, change the setting of
your vehicle’s alarm system for activation
mode. Refer to “Alarm system setting” F2-
27.
Keys and doors/Alarm system
2-27
2
Loading ...
Loading ...
Loading ...