Loading ...
Loading ...
Loading ...
03 Instruments and controls
03
}}
* Option/accessory, for more information, see Introduction.
109
Retain the original transmitter of the RF
device you are programming for use in other
vehicles as well as for future HomeLink pro-
gramming. It is also suggested that upon the
sale of the vehicle, the programmed Home-
Link buttons be erased for security purposes.
Refer to “Resetting HomeLink Buttons” in
HomeLink
®
Wireless Control System* – pro-
gramming (p. 109).
Using HomeLink
To operate, simply press and hold the pro-
grammed HomeLink button until the trained
device begins to operate (this may take sev-
eral seconds). Activation will now occur for
the trained device (i.e., garage door opener,
gate operator, security system, entry door
lock, home/office lighting, etc.). For conven-
ience, the hand-held transmitter of the device
may also be used at any time. In the event
that there are still programming difficulties or
questions, contact HomeLink at:
www.homelink.com/www.youtube.com/
HomeLinkGentex or by phoning the hotline at
1–800–355–3515.
NOTE
If the ignition is switched off, HomeLink
will function for 30 minutes after the driv-
er's door has been opened.
HomeLink
®
Wireless Control System*
– programming
The HomeLink Wireless Control System pro-
vides a convenient way to replace up to three
hand-held radio-frequency (RF) transmitters
used to activate devices such as gate opera-
tors, garage door openers, entry door locks,
security systems, even home lighting. Addi-
tional information can be found on the Inter-
net atwww.homelink.com/www.youtube.com/
HomeLinkGentex or by phoning the hotline at
1–800–355–3515.
NOTE
Some vehicles may require the ignition to
be switched on or be in the “accessories”
position for programming and/or operation
of HomeLink. It is also recommended that
a new battery be placed in the hand-held
transmitter of the device being pro-
grammed to HomeLink for quicker training
and accurate transmission of the radio-fre-
quency signal. The HomeLink buttons
must be reset first. When this has been
completed, Homelink is in learning mode
so that you can perform programming.
1. Position the end of your hand-held trans-
mitter 1–3 inches (5–14 cm) away from
the HomeLink button you wish to pro-
gram while keeping the indicator light in
view.
2. Simultaneously press and hold both the
chosen HomeLink and hand-held trans-
mitter buttons until the HomeLink indica-
tor light changes from a slow to a rapidly
blinking light. Now you may release both
the HomeLink and hand-held transmitter
buttons.
NOTE
Some devices may require you to replace
this Programming Step 2 with procedures
noted in the “Gate Operator / Canadian
Programming” section. If the HomeLink
indicator light does not change to a rapidly
blinking light after performing these steps,
contact HomeLink at www.homelink.com/
www.youtube.com/HomeLinkGentex or by
phoning the hotline at 1–800–355–3515.
Loading ...
Loading ...
Loading ...