User Manual - Page 57

For 2019 DURANGO.

Loading ...
Loading ...
Loading ...
Closing Sunroof
Express
Push the switch forward and release it within
one-half second and the sunroof will close au-
tomatically from any position. During Express
Close operation any other actuation of the sun-
roof switches will stop the sunroof in a partially
open position.
Manual Mode
Push and hold the switch forward and the sun-
roof will close from any position and stop at a
full closed position. Releasing the switch while
the sunroof is in motion will stop the sunroof in
a partially open position.
Sunshade Operation
The sunshade can be opened manually. How-
ever, the sunshade will open automatically as
the sunroof opens.
NOTE:
The sunshade cannot be closed if the sunroof is
open.
Pinch Protect Feature
This feature will detect an obstruction in the
closing of the sunroof during the Express Close
operation. If an obstruction in the path of the
sunroof is detected, the sunroof will automati-
cally retract. Remove the obstruction if this
occurs.
NOTE:
If three consecutive sunroof close attempts re-
sult in Pinch Protect reversals, Pinch Protect
will disable and the sunroof must be closed in
Manual Mode.
Sunroof Maintenance
Use only a non-abrasive cleaner and a soft cloth
to clean the glass panel.
Ignition Off Operation
NOTE:
The power sunroof switch can remain active in
Accessory Delay for up to approximately
10 minutes after the vehicle’ s ignition is
placed to the OFF position. Opening either
front door will cancel this feature.
This feature is programmable using the
Uconnect System. Refer to “Uconnect Set-
tings” in “Multimedia” in your Owner’ s
Manual for further information.
Calibration Procedure
If the sunroof Express Operation feature is no
longer functioning, or the sunroof is auto revers-
ing while attempting to Express Close but no
obstruction is in the roof opening, the sunroof
can be re-calibrated per the following steps:
1. Set the ignition to ACC or the ON/RUN.
2. Close the sunroof glass.
3. W ith the sunroof in the closed position, push
and hold the close switch.
4. After 10 seconds of holding the switch, the
sunroof glass will cycle into the vent position
and stop.
5. Release the close switch, then within five
seconds, push and hold the close switch
again. The sunroof will cycle open and back
to closed as the switch is held.
6. Once the sunroof has stopped in the full
closed position, release the close switch.
The sunroof is now reset and ready to use.
55
Loading ...
Loading ...
Loading ...