Loading ...
Loading ...
Loading ...
Start and driving
and needs to be started manually, the start
butt
on fl
ashes to indicate this situation.
Start-Stop system*
Control lamps
It lights up
The Start-Stop system is available, the automatic en-
gine shutdown is active.
It lights up
The Start-Stop system is not available or has been
disconnected.
Instructions for the driver on the instru-
ment panel displ
ay
Start-Stop system deactivated.
Start the engine manually
This indication f
or the driver shows that the
Start-Stop system cannot start the engine
again.
Start-Stop system: Fault! Function
not available
There is a fault in the Start-Stop system. Take
the vehicle to a workshop to have the fault re-
paired.
Description and operation
The Start-Stop system helps you to save fuel
and reduce CO
2
emissions.
In St
art-Stop mode, the engine will automati-
cally switch off when the vehicle stops or is
stopping. The ignition remains switched on.
The engine automatically switches back on
when required.
In this scenario, the light of the
button stays lit
1)
.
When the ignition is s
wit
ched on, the Start-
Stop function is automatically activated.
Further information about the Start-Stop sys-
tem can be found in the Easy Connect sys-
tem: press the button > View >
Vehicle status.
Vehicles with a manual gearbox
●
When the vehicle or when it is stopped, put
it into neutral and release the clutch pedal.
The engine will switch off. The warning lamp
will light up. The engine can be stopped
before stopping completely (approximately 7
km/h).
●
When the clutch pedal is pressed the en-
gine will start up again. The warning lamp will
switch off.
Vehicles with an automatic gearbox
●
Brake until the vehicle stops and keep your
foot on the brake pedal. The engine will
switch off. The warning lamp will appear in
the display. The engine can be stopped be-
fore stopping completely (approximately 7 or
2 km/h depending on the vehicle's gearbox).
●
When you take your foot off the brake ped-
al the engine will start up again. The warning
lamp will switch off.
Basic requirements for the Start-Stop
mode
●
The driver door must be closed.
●
The driver's seat belt must be fastened.
●
The bonnet must be closed.
●
The engine has reached operating temper-
ature.
●
The reverse gear must not be engaged.
●
The vehicle must not be on a very steep
slope.
»
1)
Only in vehicles with Keyless Access.
195
Loading ...
Loading ...
Loading ...