Loading ...
Loading ...
Loading ...
8-6 Do-it-yourself
JVM0728X
CHECKING ENGINE OIL LEVEL
1. Park the vehicle on a level surface and
apply the parking brake.
2. Run the engine until it reaches oper-
ating temperature.
3. Turn off the engine. Wait more than
15 minutes for the oil to drain back
into the oil pan.
4. Remove the dipstick and wipe it clean.
Reinsert it all the way.
5. Remove the dipstick again and check
the oil level. It should be within the
range
. If the oil level is below ,
remove the oil filler cap and pour
recommended oil through the open-
ing. Do not overfill
.
6. Recheck oil level with the dipstick.
It is normal to add some oil between oil
maintenance intervals or during the
break-in period, depending on the se-
verity of operating conditions.
CAUTION
Oil level should be checked regularly.
Operating the engine with an insuffi-
cient amount of oil can damage the
engine, and such damage is not
covered by warranty.
CHANGING ENGINE OIL AND FILTER
Vehicle set-up
1. Park the vehicle on a level surface and
apply the parking brake.
2. Run the engine until it reaches oper-
ating temperature.
3. Turn the engine off and wait more
than 15 minutes.
4. Raise and support the vehicle using a
suitable floor jack and safety jack
stands.
.
Place the safety jack stands under
the vehicle jack-up points.
.
A suitable adapter should be at-
tached to the jack stand saddle.
5. Remove the engine undercover.
.
Remove the bolts that hold the
undercover in place.
CAUTION
Make sure the correct lifting and
support points are used to avoid
vehicle damage.
ENGINE OIL
Loading ...
Loading ...
Loading ...