Owner's Manual - Page 272

For 2012 XC70.

Loading ...
Loading ...
Loading ...
06 During your trip
Loading
06
272
CAUTION
Be sure that there is adequate space above
and behind the vehicle before opening the
tailgate automatically.
The vehicle should not be driven or moved
with the tailgate in the open position. How-
ever, if the vehicle is moved with the tailgate
in the open position, the automatic closing
function will be inoperative until one of the
following occurs:
The tailgate is closed manually
The ignition is switched off and the key
is removed for approximately 10
minutes (the tailgate will function again
after restart).
NOTE
If the tailgate has been opened and closed
continuously too long, the automatic func-
tion will be deactivated to avoid overloading
the electrical system. The automatic func-
tion can be used again after approximately
2 minutes.
If the vehicle's battery has been discharged
or disconnected, the tailgate must be
opened and closed once manually to reset
the system.
Programming the tailgate opening angle
The tailgate's maximum opening angle can be
programmed, which can be useful, for exam-
ple, if the tailgate has to be opened in a garage
with a low ceiling.
To do so:
Open the tailgate manually, hold it at the
desired maximum opening angle and
press the tailgate's closing button for at
least 3 seconds. When the tailgate is
released, programming is complete.
To remove this programming, open the tail-
gate manually to a higher opening angle.
Automatic closing
The power tailgate can be closed by pressing
the
button on the tailgate (see the illus-
tration) or by pressing it down.
NOTE
If the tailgate is pressed down e.g., by the
weight of snow or strong wind, it will close
automatically.
WARNING
Be sure that no one is near the tailgate when
it is opened or closed automatically. The
tailgate should never be obstructed in any
way when it is operated.
Interrupting automatic opening/closing
Automatic opening or closing the tailgate can
be interrupted in four ways:
By pressing the button on the
lighting panel.
By pressing the button on the
remote key.
By pressing the button on the lower edge
of the tailgate.
By pressing the rubber-covered button
under the outer handle on the tailgate.
If one of these actions is taken, the tailgate will
stop moving.
Pinch protection
If the tailgate is obstructed while it is being
operated, the pinch protection function is acti-
vated.
If the tailgate is being opened, the electri-
cal function will be switched off and the
tailgate will be released from the electrical
system.
If the tailgate is being closed, it will stop
and move slightly in the opposite direction.
Operating the tailgate manually
The power tailgate can be disconnected from
the vehicle’s electrical system by quickly pull-
Loading ...
Loading ...
Loading ...