Loading ...
Loading ...
Loading ...
Information
42
How to attach the lens cap
1
Prepare the lens cap and the strap supplied as
accessories.
2
Insert the non-knot end of the strap into the
hole at the bottom of the lens section of the
projector.
3
Attach the strap at the hole of the projector into
the hole of the lens cap, and then pass the lens
cap through the strap lasso.
4
They are completely assembled as shown in
the below figure.
Regarding the projector lamp control
• Don’t turn off the projector until at least in 5 minutes after activating it.
- The frequent On/Off changes may cause the lamp function to deteriorate.
• Don’t pull out the power cord while the projector's cooling fan is on.
- It may cause the lamp life-span to shorten and get damaged.
• The life-span of projector depends on the use environment and treatment conditions.
• The projector uses a high pressure mercury lamp so that serious caution is essential. The shock or abuse while using may
cause lamp to blow off with explosion.
• When you continue to use the projector after an interval of lamp replacement, the lamp may be blown off with explosion.
• The following treatment should be done if the lamp shatters.
- Pull off the power cord immediately.
- Let some fresh air in immediately (Ventilation).
- Check the product condition at the nearer service center and replace the lamp, if necessary.
- Don’t try to disassemble the product.
WARNING
How to attach the lens cap to the projector
Loading ...
Loading ...