Loading ...
Loading ...
Loading ...
perlick customer service (800)558-5592 | 25
PERLICK RESIDENTIAL ICE MAKER MANUAL
17. Replace the slope in its correct posion. See Fig. 39.
18. Discard the sanizing soluon.
19. Mix a new batch of the sanizing soluon and slowly
pour it into the water tank.
20. Move the control switch to the “WASH” posion.
21. Aer circulang the sanizing soluon for 15 minutes,
move the control switch to the “OFF” posion.
22. Disconnect the sucon tube. Allow the water tank to
drain, then reconnect the sucon tube.
23. Repeat steps 19 through 22 one me.
24. Move the control switch to the “ICE” posion and
allow the icemaker to operate for 2 minutes.
This allows the water tank to ll with water.
25. Move the control switch to the “WASH” posion.
26. Allow the water to circulate for 5 minutes, then move
the control switch to the “OFF” posion.
27. Disconnect the sucon tube. Allow the water tank to
drain, then reconnect the sucon tube.
28. Repeat steps 24 through 27 two more mes to rinse
thoroughly.
29. Clean the storage bin liner, door liner, and door gasket
with a neutral cleaner. Rinse thoroughly aer cleaning.
30. Move the control switch to the “ICE” posion to start
the automac ice making process.
Slope
Fig. 39
MAINTENANCE
STAINLESS STEEL EXTERIOR
To prevent corrosion, wipe the exterior occasionally with a
clean and so cloth. Use a damp cloth containing a neutral
cleaner to wipe o oil or dirt build up.
STORAGE BIN DRAIN
In some condions, slime may build up inside the storage bin
drain and prevent water from draining properly. To prevent this
buildup, perform the following procedure once every 3 months
or as oen as necessary for condions.
If the storage bin drain becomes clogged,
water could build up in the bin and overow, leading to costly
water damage.
1. Move the control switch to the “OFF” posion
To reduce the risk of electric shock, do not
touch the control switch with damp hands.
2. Remove all ice from the storage bin.
3. Mix a batch of sanizing soluon by dilung
1.25 .oz. (37 ml or 2.5 tbs) of a 5.25% sodium
hypochlorite soluon (chlorine bleach) with
2.5 gallons (9.5 l) of warm water. Using a chlorine test
strip or other method, conrm that you have a
concentraon of about 200 ppm.
For safety and maximum eecveness, use
the soluon immediately aer diluon.
4. Slowly pour the sanizing soluon into the
storage bin.
5. Aer all of the soluon has drained, clean the storage
bin liner with a neutral cleaner. Rinse thoroughly with
clean water.
6. Move the control switch to the “ICE” posion to start
the automac ice making process.
DANGER
!
CAUTION
WARNING
Loading ...
Loading ...
Loading ...