Loading ...
Loading ...
Loading ...
22 | perlick.com/residential
PERLICK RESIDENTIAL ICE MAKER MANUAL
MAINTENANCE
CLEANING AND SANITIZING
INSTRUCTIONS
The appliance must be cleaned and sanized at least once a
year. More frequent cleaning and sanizing may be required
in some condions.
To prevent injury to individuals and damage
to the appliance, do not use ammonia type cleaners.
Carefully follow any instrucons provided
with the cleaning and sanizing soluons.
Always wear liquid-proof gloves and goggles
to prevent the cleaning and sanizing soluons from coming
into contact with skin or eyes.
DANGER
!
DANGER
!
DANGER
!
Do not use ice made from the cleaning and
sanizing soluons. Aer cleaning and sanizing, be careful
not to leave any soluon in the appliance.
Do not place ngers or any other objects
into the ice discharge opening (extruding head).
DANGER
!
DANGER
!
1. Cleaning Soluon
Dilute 4 . oz. (118 ml or 8 tbs) of Nu-Calgon “Liquid Ice
Machine Cleaner” with 1 gal (3.8 l) of warm water. This is
a minimum amount. Make more soluon if necessary. It is
recommended that cleaning be performed by a qualied
service technician.
For safety and maximum eecveness, use
the soluon immediately aer diluon.
2. Cleaning Procedure
1. Remove all ice from the storage bin.
Note: To remove cubes on the evaporator, move the
control switch to the “OFF” posion and then
move it back to the “ICE” posion aer 3
minutes. The harvest cycle starts and the cubes
will be removed from the evaporator.
2. Move the control switch to the “OFF” posion.
3. Inside the storage bin, disconnect the sucon tube by
` squeezing the tabs and pulling the tube clear.
See Fig. 26. Allow the water tank to drain.
4. Reconnect the sucon tube as illustrated. See Fig. 27.
Make sure the tabs lock into place; a loose ng may
cause a water leak.
5. Slowly pour the cleaning soluon into the water tank.
6. Move the control switch to the “WASH” posion.
7. Allow the cleaning soluon to circulate for 30 minutes,
then move the control switch to the “OFF” posion.
8. Disconnect the sucon tube. Allow the water tank to
drain, then reconnect the sucon tube.
9. Move the control switch to the “ICE” posion and
allow the icemaker to operate for 2 minutes.
This allows the water tank to ll with water.
10. Move the control switch to the “WASH” posion.
11. Allow the water to circulate for 5 minutes, then move
the control switch to the “OFF” posion.
12. Disconnect the sucon tube. Allow the water tank
to drain, then reconnect the sucon tube.
13. Repeat steps 9 through 12 three more mes to rinse
thoroughly.
Note: If you do not sanize the appliance, go to step 8 in “IV.B.5.
Sanizing Procedure - Final.”
CAUTION
Sucon Tube
Tabs
Water Tank
Drain
Fig. 26
Sucon Tube
Tabs
Fig. 27
Loading ...
Loading ...
Loading ...