Loading ...
Loading ...
Loading ...
20 | perlick.com/residential
PERLICK RESIDENTIAL ICE MAKER MANUAL
WATER SUPPLY AND DRAIN CONNECTIONS / FINAL CHECKLIST / STARTUP
An air gap of a minimum of 2 vercal inches (5 cm) must be
between the end of the drain pipe from the appliance and the
oor drain.
For gravity drain installaon, drain must have 1/4” fall per foot
(2 cm per 1 m) on horizontal runs to get good ow. A vented
tee connecon is also required for proper ow. Extend the vent
at least 12” (30 cm) above the drain outlet. For oponal drain
pump (63802A) installaon, refer to the instrucons included
with the pump.
FINAL CHECKLIST
CHOKING HAZARD: Ensure all components,
fasteners, and thumbscrews are securely in place aer
installaon. Make sure that none have fallen into the
storage bin.
1. Is the appliance level?
2. Is the appliance in a site where the ambient temperature
is within 45°F to 100°F (7°C to 38°C) and the water
temperature within 45°F to 95°F (7°C to 35°C) all year
around?
3. Have the shipping carton, tape, and packing material been
removed from the appliance? Has the protecve plasc
lm been removed from the panels?
4. Have all electrical and water connecons been made? Do
electrical and water connecons meet all naonal, state,
and local code and regulaon requirements?
5. Has the power supply voltage been checked or tested
against the nameplate rang? Is the power supply a
properly grounded, independent 3-prong wall outlet?
6. Are the water supply and drain lines sized as specied?
Are the water supply line shut-o valve and drain valve
installed? Has the water supply pressure been checked to
ensure a minimum of 10 PSIG and a maximum of 113 PSIG?
7. Are all components, fasteners, and thumbscrews securely
in place?
8. Has the end user been given this instrucon manual,
and instructed on how to operate the appliance and the
importance of the recommended periodic maintenance?
9. Has the end user been given the name and telephone
number of an authorized service agent?
10. Has the warranty tag been lled out and forwarded to the
factory for warranty registraon?
DANGER
!
STARTUP
All parts are factory-adjusted. Improper
adjustments may adversely aect safety, performance,
component life, and warranty coverage.
If the appliance is turned o, wait for at least
3 minutes before restarng the appliance to prevent damage to
the compressor.
At startup, conrm that all internal and
external connecons are free of leaks.
1. Open the water supply line shut-o valve.
2. Make sure the control switch is in the “OFF” posion. Plug
the appliance into the electrical outlet.
To reduce the risk of electric shock, do not
touch the control switch or plug with damp hands. If you
have to slide the appliance back for a built-in installaon,
make sure you do not damage or pinch the water supply line,
drain line, or power cord.
3. If required by sanitaon code in your area, seal the
perimeter where the appliance touches the oor with
approved caulk compound in a smooth and easily cleanable
manner.
4. Move the control switch to the “ICE” posion to start the
automac ice making process.
5. Once the appliance starts to produce ice, allow it to run for
another 30 minutes.
6. Move the control switch to the “OFF” posion.
DANGER
!
WARNING
WARNING
DANGER
!
Loading ...
Loading ...
Loading ...