Loading ...
Loading ...
Loading ...
perlick customer service (800)558-5592 | 23
PERLICK RESIDENTIAL ICE MAKER MANUAL
MAINTENANCE
3. Sanizing Soluon
Dilute 0.5 . oz. (14.8 ml or 1 tbs) of a 5.25% sodium
hypochlorite soluon (chlorine bleach) with 1 gallon
(3.8 l) of warm water. This is a minimum amount. Make
more soluon if necessary. Using a chlorine test strip or
other method, conrm that you have a concentraon
of about 200 ppm.
For safety and maximum eecveness, use
the soluon immediately aer diluon.
4. Sanizing Procedure
1. Make sure the control switch is in the “OFF” posion
and the storage bin is empty.
2. Remove the slope from the storage bin by carefully
bending it in the center and releasing it from the 2
slope shas. See Fig. 28.
3. Remove each separator by liing it to the horizontal
posion and pushing it hard inward. See Fig. 29.
4. Disconnect the sucon tube. Allow the water tank to
drain.
5. Spread out the tabs to unlock the water tank, them
slide it out. See Fig. 30.
6. Li o the ice chute from the frame pipe and
then from the rear frame pipe. See Fig. 31.
Ensure all components, fasteners, and
thumbscrews are securely in place. Make sure that none have
fallen into the storage bin.
7. Disconnect the discharge tube from the spray
assembly, then slide out the spray assembly.
See Fig. 32.
CAUTION
Separator
Fig. 29
Tab
Fig. 30
Tab
Water Tank
Rear Frame Pipe
Fig. 31
Ice Chute
Front Frame Pipe
Slope
Fig. 28
Slope Shas
Fig. 32
Discharge Tube
Spray Assembly
DANGER
!
Loading ...
Loading ...
Loading ...