Loading ...
Loading ...
Loading ...
24 | perlick.com/residential
PERLICK RESIDENTIAL ICE MAKER MANUAL
MAINTENANCE
8. Remove the two caps. See Fig. 33.
9. Soak all of the removed parts and the scoop in the
sanizing soluon for 10 minutes. If the spray
assembly nozzles are clogged, clean them with a wire
or a suitable brush.
10. Rinse the parts thoroughly with clean water.
11. Ret the 2 caps in their correct posions. Make sure
the reducing pipe is in place in the center.
See Fig. 34.
12. Slide in the spray assembly along the rails on the le
and right brackets. See Fig. 35. Connect the discharge
tube securely to the spray assembly; a loose ng
may cause a water leak.
13. Posion and lock the ice chute onto the front and rear
frame pipes by pushing the ice chute down unl it
clicks onto both frame pipes. See Fig. 36.
14. Slide in the water tank along the rails at the boom of
the le and right brackets unl it locks into place.
See Fig. 37.
15. Reconnect the sucon tube.
16. Hook each separator onto the rail, then pull it hard
towards you unl it locks into place. See Fig. 38.
Fig. 33
Caps
Fig. 34
Caps
Reducing Pipe
Le Bracket Right Bracket
Rail
Rail
Discharge Tube
Fig. 35
Ice Chute
Rear Frame Pipe
Front Frame Pipe
Fig. 36
Fig. 37
Le Bracket
Right Bracket
Rail Rail
Water Tank
Rail
Separator
Fig. 38
Loading ...
Loading ...
Loading ...