Loading ...
Loading ...
Loading ...
EN – 49
10. With a snap ring pliers, remove retaining ring. See
Figure 118.
See Figure 119.
11. With a driver, strike impeller shaft end until shaft is
through front of gearcase.
NOTICE: DO NOT strike impeller shaft end without using a
driver.
12. Remove pin and bushing from impeller shaft.
13. Remove impeller shaft from gearcase and remove all
loose parts from inside gearcase.
14. Remove seals and flange bushings from gearcase.
See Figure 120.
Assemble Gearcase
See Figure 121.
1. Press rear seal into gearcase until flush with gearcase
exterior.
2. Reinstall right and rear flange bushings.
IMPORTANT: Gear is symmetrical and may be installed in
either orientation.
3. Install gear into gearcase.
Figure 118
Figure 119
Figure 120
Figure 121
Loading ...
Loading ...
Loading ...