Loading ...
Loading ...
Loading ...
EN – 26
AUGER GEARCASE REPLACEMENT
Remove Gearcase Assembly
IMPORTANT: Save all hardware for reinstallation.
1. Stop engine, remove key and wait for all moving parts
to stop and for hot parts to cool.
2. Disconnect spark plug wire from engine.
3. Remove augers. See Remove Auger on page 22.
See Figure 56.
4. Remove hardware retaining support brackets to
gearcase and remove brackets.
5. Remove two flat steel washers from auger shaft.
See Figure 57.
6. Remove two roll pins retaining impeller to impeller
shaft and remove impeller.
IMPORTANT: Use of penetrating oil or heat may be
necessary to remove impeller.
Install Gearcase Assembly
1. Install impeller onto impeller shaft.
2. Align holes in impeller with holes in impeller shaft and
reinstall roll pins.
3. Reinstall one flat steel washer onto each auger shaft
end.
4. Reinstall support brackets to gearcase and secure
with two extension locking washers and hex bolts. See
Figure 56.
5. Reinstall augers. See Install Auger on page 24.
6. Reconnect spark plug wire.
Figure 56
1. Hex Bolt
2. Extension Locking Washer
3. Support Bracket
1
2
3
Figure 57
Loading ...
Loading ...
Loading ...