Loading ...
Loading ...
Loading ...
132 GETTING TO KNOW YOUR INSTRUMENT PANEL
Speed Warning — If Equipped
Push and release the up or down arrow
button until Speed Warning is highlighted in the
instrument cluster display. Push and release
the OK button to enter Speed Warning. Use the
up or down arrow button to turn the
Speed Warning ON or OFF, then push and
release the OK button to confirm the selection.
If the ON status is selected, use the up or
down arrow button to set the desired speed,
then push the OK button to set the speed for the
Speed Warning. A Speed Warning telltale will
illuminate in the instrument cluster, with a
number matching the set speed, with a pop-up
message to inform the driver that the Speed
Warning has been set to the desired speed.
Each time the set speed is exceeded, a single
chime will sound and a pop-up warning
message will display. If the set speed is
exceeded more than 2 mph (3 km/h), a
continuous chime will sound for up to 10
seconds, or until the speed is no longer
exceeded. The telltale in the instrument cluster
will also change from white to yellow, and a
pop-up warning message will pop-up on the
instrument cluster display.
NOTE:
Speed Warning is unavailable while KeySense
is in use.
BATTERY SAVER ON/BATTERY SAVER
M
ODE MESSAGE — ELECTRICAL LOAD
R
EDUCTION ACTIONS — IF EQUIPPED
This vehicle is equipped with an Intelligent
Battery Sensor (IBS) to perform additional
monitoring of the electrical system and status
of the vehicle battery.
In cases when the IBS detects charging system
failure, or the 12 Volt vehicle battery conditions
are deteriorating, electrical load reduction
actions will take place to extend the driving time
and distance of the vehicle. This is done by
reducing power to or turning off non-essential
12 Volt electrical loads. Load reduction will be
functional when the vehicle propulsion system
is active.
The vehicle may not be running depending on
the High Voltage (HV) battery State Of Charge
(SOC) or temperature. It will display a message
if there is a risk of battery depletion to the point
where the vehicle may stall due to lack of
electrical supply, or will not restart after the
current drive cycle.
When 12 Volt load reduction is activated, the
message “Battery Saver On” or “Battery Saver
Mode” will appear in the instrument cluster
display.
These messages indicate the vehicle battery
has a low state of charge and continues to lose
electrical charge at a rate that the charging
system cannot sustain.
NOTE:
The charging system is independent from
load reduction. The charging system
performs a diagnostic on the charging
system continuously.
If the Battery Charge Warning Light is on it
may indicate a problem with the charging
system Ú page 135.
The electrical loads that may be switched off (if
equipped), and vehicle functions which can be
effected by load reduction:
Heated Seat/Vented Seats/Heated Wheel
Heated/Cooled Cup Holders — If Equipped
Rear Defroster And Heated Mirrors
HVAC System
21_RUP_OM_EN_USC_t.book Page 132
Loading ...
Loading ...
Loading ...