Loading ...
Loading ...
Loading ...
(1) IMPELLER
(2) COPPER WASHER
(3) WATER PUMP SHAFT
(4) WASHER
Water Seal And Bearing Replacement
Drain the transmission oil (page 3-8).
Remove the following:
– Water pump cover bolt/cover/dowel pins/O-ring
– Right crankcase cover and washer (page 4-40)
Hold the water pump gear teeth using a suitable tool,
then remove the impeller, copper washer and water pump
shaft.
(1) BOLTS
(2) WATER PUMP COVER
Install the air cleaner housing onto the frame and connect
the crankcase breather hose.
Install and tighten the air cleaner housing mounting nuts
and bolt securely.
Install the washer and muffler mounting bolt, then tighten
the bolt securely.
Adjust the angle of the connector tube clamp and tighten
the screw firmly.
Install the rear fender.
(1) AIR CLEANER HOUSING
(2) BOLTS/NUTS
Install the throttle body together with insulator at cylinder
head inlet port.
Make sure there are the following clearances between the
throttle body:
– Throttle body-to-bank angle sensor: more than 5 mm
– Throttle body-to-muffler: more than 5 mm
Adjust the insulator band angle and tighten the band
screw securely.
Connect the ECM 32P (Black) connector.
(1) THROTTLE BODY
(2) BAND SCREW
(3) 32P (BLACK) CONNECTOR
Engine servicing
4-15
4-15
1
2
2
1
4
3
2
1
1
2
3
Loading ...
Loading ...
Loading ...