Loading ...
Loading ...
Loading ...
Pour half the required amount of recommended fork fluid
in the fork tube.
Specified fork fluid:
OJ Racing Special Fork Oil Type 01 (SAE 5W) or
equivalent
Pump the fork tube slowly 8-10 times.
Pour additional fluid to the specified capacity.
Oil level: 125 mm (4.9 in)
Oil capacity (orientative): 285 cc
(9.6 US oz)
(10.0 Imp oz)
NOTICE
Totally extending fork may cause oil leakage.
(1) GUIDE BUSHING
(2) BACK-UP RING
(3) OIL SEAL
(4) STOP RING
(5) DUST SEAL
Install the following parts onto the fork tube using the
same procedure as the right fork (page 5-6):
– Fork tube bushing
– Guide bushing
– Back-up ring
Using the special tool, drive the guide bushing and back-
up ring until the stop ring groove is fully stuck in the fork
slider base.
Install the oil seal (spring up) in the fork slider. Drive the
oil seal using the special tool, performing a constant pres-
sure until stops in back-up ring.
Tool:
Fork seal driver 07947–4630100
Install the stop ring into the slider groove securely.
Install the dust seal.
Hold the axle holder in a vise protected with a piece of
wood or soft jaws to avoid damage.
Do not overtighten the vise.
Install the center bolt with a new sealing washer.
Tighten the center bolt to the specified torque.
Torque: 23.5-25.5 N•m (2.4-2.6 kgf•m, 17.3-18.8 lbf•ft)
(1) CILINDER ASSY
(2) CENTER BOLT
5-10
5-10
Frame servicing
2
1
5
4
3
2
1
Loading ...
Loading ...
Loading ...