Loading ...
Loading ...
Loading ...
(1) LOWER MOUNTING BOLT/NUT
(2) BOLTS/NUTS
(3) CUSHION ARM PLATES
(4) CUSHION LINK
Shock Linkage
Removal
Raise the rear wheel off the ground with a block or
maintenance stand under the engine.
Remove the following:
– Rear cushion lower mounting bolt/nut
– Cushion arm plate-to-cushion link bolt/nut
– Cushion arm plates-to-swingarm bolt/nut
– Cushion arm plates
– Cushion link-to-frame socket bolt/nut
– Cushion link
Move the swingarm aligning the lower mount, then install
the lower mounting bolt from the right side.
Install and tighten the upper and lower mounting nuts to
the specified torque.
Torque:
Upper mounting bolt: 39 N•m (4.0 kgf•m, 29 lbf•ft)
Lower mounting bolt: 39 N•m (4.0 kgf•m, 29 lbf•ft)
(1) LOWER MOUNTING BOLT/NUT (1) PIVOT COLLAR A
(2) PIVOT COLLAR B
(3) DUST SEALS
(4) NEEDLE BEARINGS
Needle Bearing Replacement
Remove the pivot collars and dust seals.
Check the cushion link needle bearings for damage.
Remove the cushion link needle bearings using the special
tool.
Tool:
Bearing driver 07946-MJ0A100
Press new needle bearings into the cushion link to 3 mm
(0.12 in) below the surface of the cushion link using the
special tool, on both sides.
Face the bearing with its marked side facing out.
Tool:
Bearing driver 07946-MJ0A100
Apply multi-purpose grease to the collars and dust seal
lips.
Install the dust seals and pivot collars.
5-19
5-19
Frame servicing
4
3
3
2
1
2
2
4
4
3
3
2
1
3 mm
(0.12 in)
1
Loading ...
Loading ...
Loading ...