Loading ...
Loading ...
Loading ...
32
Cleaning the pump filter
The pump has a filter to trap foreign objects that enter the washer along with clothing.
The pump filter can be accessed from the front of the washer. The washer will notify
you to check the filter every 100 cycles. If this is not addressed it will become a warning.
(Refer to page 35)
To clean the filter:
1
Unplug the washer from the power socket on the wall.
2
Use a coin to open the filter cover. Place the edge of
thecoin into the slot and tilt upwards whilst levering
thecover open.
3
Unhook the pump outlet hose and pull it out (about
150mm). Remove the plug and allow any water
(approximately 250ml) to drain into a shallow dish.
4
After the draining process is complete, replace the plug
intothe hose and refit the hose back into the housing.
5
Remove the filter by turning anti-clockwise (refer toA).
Clean and rinseunder a tap. Check the pump filter
cavityforany further obstruction.
6
Replace the filter by turning clockwise until the turning
handle stops in the vertical position, and cannot be
turnedfurther (refer to A).
7
Close the filter cover.
Cleaning the hoses
Each inlet hose has a filter in it, preventing any solid contaminants in the water from
entering your washing machine. Occasionally you should disconnect the water inlet
hoses where they connect to the taps, check these for any build up of dirt and wash
the filters out.
Drain residual water
Removing/replacing filter
Turn filter clockwise until turning handle
stops in vertical position and tabs meet
A
Tabs
CARING FOR YOUR WASHER
Loading ...
Loading ...
Loading ...