Loading ...
Loading ...
Loading ...
12
INSTALLATION INSTRUCTIONS
Completing the installation
Installation test cycle
IMPORTANT!
Do this before you wash any items in your washer. This is to check that your washer
is installed correctly and that it is functioning properly prior to use. We recommend
you complete an initial manual cycle with an empty drum and half a dose of detergent
in order to remove any residues from the manufacturing process.
1
Turn your washer on by pressing the ‘POWER’ button.
2
Select ‘Manual’ and put half a dose of detergent into the ‘Manual Dose’ compartment.
2
Select the ‘Quick 30’ cycle. Ensure the drum is empty and the door closed.
3
Touch the button. The washer will start to fill.
– Observe the washer for any problems (eg leaking from the hoses, excess noise
orvibrations).
– The washer will beep and display any faults on the screen if there are any
problems. Refer to the ‘Before you call for service’ at the back of this book.
4
Continue to observe until you see water in the bottom of the drum.
5
Touch to pause the cycle, then press ‘POWER’ to turn the washer off.
6
Press ‘POWER’ again, select the ‘Spin’ cycle and touch .
– Check that the drain hose is firmly secured to the standpipe, or tub or spigot.
– Observe that the washer pumps out the water and spins.
IMPORTANT!
If there are any problems, you must address these before proceeding with normal use.
The washer will automatically turn off at the end of the cycle if there are no problems.
Loading ...
Loading ...
Loading ...