Loading ...
Loading ...
Loading ...
©2017 Pinnacle Climate Technologies 26 Vent-Free Gas Log Heater User Manual
Remote Control Operation
MULTI-FUNCTION WIRELESS REMOTE CONTROL SYSTEM FOR OPERATING A LATCHING
SOLENOID VALVE, MANUALLY OR WITH A THERMOSTAT FUNCTION
This remote control system was developed to provide a convenient, user-friendly, and safe remote control
system for gas heating appliances. The system is operated manually from the transmitter and operates on
radio frequencies (RF) within a 20-foot range using non-directional signals. The system uses one of over
a million security codes that are programmed into the transmitter at the factory. Before the rst use, the
remote receiver’s code must be matched to the transmitter’s code.
NOTE: Review COMMUNICATION SAFETY under the GENERAL INFORMATION section. This safety feature
shuts down the appliance during potentially hazardous or unsafe conditions.
This remote control system provides you with a battery-operated remote control to power a latching solenoid
such as those used with gas valves in certain heater-rated gas logs, gas replaces, and other gas heating
appliances (see Fig. 33).
Using the battery power from the receiver, the solenoid
circuit operates a solenoid. The circuit uses reversing polarity
software to reverse the positive (+) and negative (-) output of
the receiver’s battery power, which drives a latching solenoid
ON/OFF. The system is controlled by the remote transmitter,
which operates on two (2) 1.5 V AAA batteries.
Always use alkaline batteries for longer battery life and
maximum performance. Do not use rechargeable batteries.
Before using the transmitter, place the two (2) AAA batteries
in the battery compartment. Ensure the batteries are placed in
the proper direction.
IF YOU CANNOT READ OR UNDERSTAND THESE INSTALLATION INSTRUCTIONS,
DO NOT ATTEMPT TO INSTALL OR OPERATE THIS DEVICE.
WARNING
Key Settings
ON Turns the heater ON. Manually operated solenoid ON.
OFF Turns the heater OFF. Manually operated solenoid OFF.
MODE Changes the heater from manual mode to thermo mode.
SET Sets the temperature in thermo mode.
Fig. 33—Remote/Transmitter
ON
MODE
WALL CLIP
SLOT
BATTERY
COMPARTMENT
OFF
SET
ON Button
OFF Button
MODE Button
SET Button
Battery
Compartment
Wall
Clip
Slot
Loading ...
Loading ...
Loading ...