Remington REM-L180ANT-F User Manual

Loading ...

LIGHTING INSTRUCTIONS

1. STOP! Read all the above safety information before proceeding.

NOTE: When used as a vented decorative appliance, use of the

thermostat function is prohibited—operate manually only.

2. Turn the control knob clockwise to the “OFF” position

(see Fig. 26).

3. Wait ve (5) minutes to clear out any gas. Then smell for gas,

including near the oor. If you smell gas, STOP! Follow “B” in

the safety information above. If you don’t smell gas, go to the

next step.

4. Turn the control knob counterclockwise to the “PILOT”

position. Depress control knob.

5. With control knob depressed, push down on the ignitor button

until the pilot lights. The pilot is located behind the heater

screen near the rear of the burner (see Fig. 27).

• Do not attempt to light the pilot by hand.

6. Keep the control knob depressed for (30) seconds after the

pilot lights. Then release the control knob.

• If the control knob does not pop up when released, stop and

immediately call a qualied service technician or gas supplier.

• If the pilot goes out, repeat steps 3 through 7. Wait (1) minute

before attempting to light pilot again. If after several tries the pi-

lot still goes out, turn the gas control knob clockwise to

the “OFF” position and call a qualied service technician.

7. Turn the control knob counterclockwise to the desired

setting.

Operation—REM-L180ALT-F / REM-L180ANT-F / REM-L240ALT-F / REM-L240ANT-F

Fig. 26—Control Knob

Fig. 27—Pilot

TO TURN OFF GAS TO THE HEATER

1. Turn the control knob clockwise to the “OFF” position.

Shutting O the Burner Only (Pilot Stays Lit):

1. Turn the control knob clockwise to the “PILOT” position.

THERMOSTATIC CONTROL OPERATION

The thermostatic control valve on this heater is dierent from standard thermostats. Standard thermostats simply

turn the burner on and o. The thermostat sensing bulb on the control valve used on this heater senses changes

in room temperature and varies the ame accordingly. The burner will shut o completely when the room

temperature exceeds the set temperature. When the room temperature drops below the set temperature, the

unit will cycle back on. The control knob can be set to the desired comfort level between 1 and 5.

The replace screen must be in place while the heater is in operation.

WARNING

Any glass doors must be completely opened while the heater is operating.

WARNING

Loading ...

Remington REM-L180ANT-F 18-in 30000-BTU Dual-Burner Vent-Free Gas Fireplace Logs with Thermostat