Loading ...
Loading ...
Loading ...
©2017 Pinnacle Climate Technologies 24 Vent-Free Gas Log Heater User Manual
LIGHTING INSTRUCTIONS
Operation—REM-L240CLR-F / REM-L240CNR-F
1. STOP! Read all the above safety information before proceeding.
2. Set the receiver switch to the “ON” position (see Fig. 28).
NOTE: When used as a vented decorative appliance, use of the
thermostat function is prohibited—operate manually only.
3. Turn the control knob clockwise to the “OFF” position
(see Fig. 28).
4. Wait ve (5) minutes to clear out any gas. Then smell for gas,
including near the oor. If you smell gas, STOP! Follow “B” in
the safety information above. If you don’t smell gas, go to the
next step.
5. Push in slightly and turn the control knob counterclockwise
to the “PILOT” position (see Fig. 28). Depress the control knob.
6. With the control knob depressed, push down on the ignitor
button until the pilot lights. The pilot is located behind log #3
near the center of the burner (see Fig. 29).
7. Keep the control knob depressed for (30) seconds after the
pilot lights. Release the control knob.
• If the control knob does not pop up when released, stop and
immediately call a qualied service technician or gas supplier.
• If the pilot goes out, repeat steps 3 through 7. Wait (1) minute
before attempting to light the pilot again. If after several tries the
pilot still goes out, turn the gas control knob clockwise to
the “OFF” position and call a qualied service technician.
8. Turn the control knob counterclockwise to the “ON” position.
9. To use the included thermostatic remote control, set the
receiver switch to the “REMOTE” position (see Fig. 30). Press the
“ON” button to turn on the remote to ignite the main burner.
Refer to the remote control instruction manual on page 25 for
the “MODE” and “SET” functions.
Fig. 28—Receiver and
Control Knob
Fig. 29—Pilot
Fig. 30—Remote/
Transmitter
The replace screen must be in place while the heater is in operation.
WARNING
Any glass doors must be completely opened while the heater is operating.
WARNING
TO TURN OFF GAS TO THE HEATER
1. Set the thermostat to the lowest setting.
2. Press the “OFF” button on the remote control.
3. Push in slightly and turn the control knob clockwise to the “OFF” position.
ONOFF
REMOTE
LEARN
ON
OFF
MODE
SET
Loading ...
Loading ...
Loading ...