Loading ...
Loading ...
Loading ...
en Troubleshooting
32
Fault Cause and troubleshooting
lights up permanently in the
display.
The water tank is empty.
▶
Fill the water tank.
→"Filling the water tank", Page13
The water tank has not been put in fully.
▶
Slide the water tank back in fully.
The water tank is leaking.
▶
Order a new water tank.
The sensor is defective.
▶
Call the after-sales service.
→"Customer Service", Page33
lights up in the display. Build-up of limescale in the appliance.
▶
Run the descaling programme in full.
→"Descaling", Page26
appears in the display. The power supply has been disconnected or the appliance has been switched
off during the descaling process.
▶
Run the interrupted descaling programme in full.
→"Descaling interrupted", Page27
During operation with steam as-
sistance, steam escapes from the
ventilation slots.
Steam escapes for physical reasons.
▶
Wait until the cooking with steam assistance ends.
After the end of cooking with steam assistance, no more steam will escape
after a short time.
After using the steam assistance,
the cooking result is too dry or
too moist.
Steam intensity set incorrectly.
▶
Set a higher or lower steam intensity.
HomeConnect is not working cor-
rectly.
Different causes are possible.
▶
Go to www.home-connect.com.
21.2 Replacing the oven light bulb
If the light in the cooking compartment fails, change
the oven light bulb.
Note:Heat-resistant, 40-watt, 230 V halogen bulbs are
available from the after-sales service or specialist retail-
ers. Only use these bulbs. Hold the new halogen bulbs
only with a clean, dry towel. This increases the service
life of the bulb.
WARNING‒Risk of burns!
The appliance gets very hot.
▶
Never touch the inside surfaces of the cooking com-
partment or the heating elements while they are hot.
▶
Always allow the appliance to cool down.
▶
Keep children at a safe distance.
WARNING‒Risk of electric shock!
When changing the bulb, the bulb socket contacts are
live.
▶
Before replacing the bulb, unplug the appliance
from the mains or switch off the circuit breaker in
the fuse box.
Requirements
¡ The appliance is disconnected from the power sup-
ply.
¡ The cooking compartment has cooled down.
¡ You have a new halogen bulb to replace the old one.
1.
Place a tea towel in the cooking compartment to
prevent damage.
2.
Turn the glass cover anti-clockwise to remove it .
3.
Pull out the halogen bulb without turning it .
4.
Insert the new halogen lamp and press it firmly into
the socket.
Make sure the pins are positioned correctly.
5.
Depending on the appliance model, the glass cover
may have a sealing ring. Put the sealing ring in posi-
tion.
6.
Screw the glass cover on.
7.
Take the tea towel out of the cooking compartment.
8.
Connect the appliance to the power supply.
Loading ...
Loading ...
Loading ...