Loading ...
Loading ...
Loading ...
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there is
no guarantee that interference will not occur in a
particular installation. If this equipment does cause
harmful interference to radio or television reception,
which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and
receiver.
– Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
– Consult the dealer or an experienced radio/TV
technician for help.
Some cordless telephones operate at frequencies that
may cause interference to nearby TVs and VCRs. To
minimize or prevent such interference, the base of the
cordless telephone should not be placed near or on top
of a TV or VCR. If interference is experienced, move the
cordless telephone further away from the TV or VCR.
This will often reduce or eliminate interference.
FCC RF Exposure Warning:
L This product complies with FCC radiation exposure
limits set forth for an uncontrolled environment.
L To comply with FCC RF exposure requirements, the
base unit must be installed and operated 20 cm (8
inches) or more between the product and all person’s
body.
L This product may not be collocated or operated in
conjunction with any other antenna or transmitter.
L The handset may be carried and operated with only the
specific provided belt-clip. Other non-tested belt-clips
or similar body-worn accessories may not comply and
must be avoided.
FCC Declaration of Conformity
Trade Name:
Panasonic
Model Number:
KX-TG9581
Responsible Party: Panasonic Corporation of North
America
Two Riverfront Plaza,
Newark, NJ 07102-5490
http://www.panasonic.com/contactinfo
FCC Warning:
To ensure compliance with FCC emissions limits, use
only the provided USB cable with ferrite core when
connecting the unit to a computer.
Notice
L FCC ID can be found inside the battery compartment
or on the bottom of the units.
Compliance with TIA-1083 standard:
Telephone handsets identified with this logo have
reduced noise and interference when used with T-Coil
equipped hearing aids and cochlear implants.
T
Compatible with
Hearing Aid T-Coil
TIA-1083
Charge only mode
The charge only mode is the dedicated mode to
charge the back-up batteries of the base unit. Do not
use this mode if it is unnecessary because all functions
except the base unit's battery charge is disabled with
this feature on. Leave all the registered handsets on
the chargers during use of the charge only mode.
To activate the charge only mode:
1 Disconnect the telephone line cord, the AC
adaptor plug, and remove the batteries from
the base unit with the corded handset placed
on the base unit.
2 Press and hold 3, {s}, and {HOLD} at the
same time, then insert the AC adaptor plug to
the base unit.
Keep on pressing these keys until:
– a beep tone sounds, and
– the {L1}/{L2} for ANSWER ON/OFF and
SP-PHONE indicators once turn on and off.
3 Release these keys.
L LCD turns off.
4 Insert batteries.
L The batteries are started to be charged.
Note:
L If the LCD is still on when you release the keys, the
base unit is not in the charging only mode. Repeat
from step 1. The charge only mode is canceled
when the corded handset comes off during or after
setting up.
To deactivate the charge only mode:
– Lift the corded handset from the base unit and
replace it.
– Press any key.
– 24 hours passed after activating the charge only
mode.
For assistance, please visit http://www.panasonic.com/help
81
Useful Information
TG958x_0704_ver031.pdf 81 2014/07/04 10:32:29
Loading ...
Loading ...
Loading ...