Loading ...
Loading ...
Loading ...
General instrument panel
bottom buttons of the rocker
sw
it
c
h ›››
Fig. 33
B
.
–
Pr
e
s
s the button
to change
the hour
, so th
at
it is flashing.
–
To continue setting the time,
press button
0.0/SET
. Hold button
do
wn t
o s
croll through the num-
bers quickly.
–
Press the
button again to
c
h
an
ge the minutes, so that it
flashes.
–
To continue setting the time,
press button
0.0/SET
. Hold button
do
wn t
o s
croll through the num-
bers quickly.
–
Press button
again to end the
c
loc
k
setting.
CAUTION
●
When the engine is
cold, avoid high revs
and heavy acceleration and do not make the
engine work hard.
●
To prevent damage to the engine, the revo-
lution counter needle should only remain in
the red zone for a short period of time.
For the sake of the environment
Changing up a gear in time reduces fuel con-
sumption and noise.
Indications on the display
A variety of information can be viewed on the
instrument
panel display ››› Fig. 95
2
, de-
pending on the v
ehicle equipment:
●
Warning and information messages.
●
Odometer.
●
Time.
●
Outside temperature.
●
Selector lever positions ››› page 143.
●
Recommended gear (manual gearbox)
›››
page 143.
●
Multifunction display (MFI)
›››
page 22
●
Service interval display
›››
page 90.
●
Start-Stop system status display
›››
page 161.
●
Fuel gauge
›››
page 182.
●
Seat belt status display for rear seats
›››
page 52.
Warning and information messages
The system runs a check on certain compo-
nents and functions when the ignition is
switched on and while the vehicle is moving.
Faults in the operation are displayed on the
screen using red and yellow symbols on the
instrument panel display (
›››
page 24)
and, in some cases, with audible warnings.
The display may vary according to the type of
instrument panel fitted.
Priority 1 warning (red symbols)
Symbol flashing or lit; partly combined with audible
warnings.
Stop the vehicle! It is dangerous ››› !
Check the function that is faulty and repair it. If necessa-
ry, request assistance from specialised personnel.
Priority 2 warning (yellow symbols)
Symbol flashing or lit; partly combined with audible
warnings.
A faulty function, or fluids which are below the correct
levels may cause damage to the vehicle! ›››
Check the faulty function as soon as possible. If neces-
sary, request assistance from specialised personnel.
Odometer
The odomet
er
r
egisters the total distance
travelled by the car.
The odometer (trip) shows the distance
travelled since the last odometer reset. The
last figure indicates 100 m.
Outside temperature indicator!
When the outside temperature is below +4 °C
(+39 °F), the symbol “ice crystal” (warning of
risk of freezing) is also displayed next to the
temperature. At first this symbol flashes and
then it remains lit until the outside tempera-
ture rises above +6 °C (+43 °F)
›››
.
When the
v
ehic
le is stationary or travelling at
very low speeds, the temperature displayed
may be slightly higher than the actual
»
89
Technical dataAdviceOperationEmergenciesSafety
Loading ...
Loading ...
Loading ...