Loading ...
Loading ...
Loading ...
21
16. TECHNICAL DATA
Voltage: 120 V~ 60 Hz max. 10A
Power: 1250W
Pressure: 1.5MPa (15 bars)
Max. water tank capacity: 60,86 . oz/1.8 l
Size LxDxH: 240x430x350 mm
Cord length: 1350 mm
Weight: 342,15 oz/ 9.7 kg
Max. beans container capacity: 8.82 oz/ 250 g
17. DISPLAYED MESSAGES
DISPLAYED MESSAGE POSSIBLE CAUSE REMEDY
FILL TANK Insucient water in the tank (A9). Fill the tank with water and/or insert it correct-
ly, pushing it as far as it will go until it clicks
into place (g. 3).
EMPTY GROUNDS CONTAINER The grounds container (A14) is full. Empty the grounds container and drip tray
(A18), clean and replace (g. 25). Important:
when removing the drip tray, the grounds con-
tainer must be emptied, even if it contains few
grounds. If this is not done, when you make
the next coees, the grounds container may ll
up more than expected and clog the machine.
INSERT GROUNDS CONTAINER After cleaning, the grounds container has not
been replaced (A14).
Remove the drip tray (A18) and insert the
grounds container.
ADD PREGROUND COFFEE The "pre-ground coee" function has been se-
lected without placing any pre-ground coee
in the funnel (A6).
Place pre-ground coee in the funnel (g. 15)
or deselect the "pre-ground" function.
GROUND TOO FINE ADJUST
MILL
The grinding is too ne and the coee is deliv-
ered too slowly or not at all.
Repeat coee delivery and turn the grind-
ing adjustment dial (A2) (g. 11) one click
clockwise towards 7 while the coee mill is
in operation. If after making at least 2 coees
delivery is still too slow, repeat the correction
procedure, turning the grinding adjustment
dial another click until delivery is correct (see
section “9.4 Adjusting the coee mill”). If the
problem persists, make sure the water tank
(A9) is fully inserted.
If the water softener lter (C4) is present, an
air bubble may have been released inside the
circuit, obstructing delivery.
Insert the hot water spout (C6) in the appli-
ance and deliver a little water until the ow
becomes regular.
DESCALE The machine must be descaled. The descaling procedure described in section
“13. Descaling” needs to be performed.
LESS COFFEE Too much coee has been used. Select a milder taste by pressing the dial
(B6) (g. 8) or reduce the quantity of
pre-ground coee.
FILL BEANS CONTAINER The coee beans have run out. Fill the beans container (A7) (g. 12).
The pre-ground coee funnel (A6) is clogged. Empty the funnel with the help of the brush
(C5) as described in section “12.8 Cleaning the
pre-ground coee funnel”.
INSERT INFUSER ASSEMBLY The infuser (A11) has not been replaced after
cleaning.
Insert the infuser as described in section ““12.9
Cleaning the infuser”.
INSERT TANK The tank (A9) is not correctly in place. Insert the tank correctly and press as far as it
will go (page 3B).
Loading ...
Loading ...