ECAM23120SB Instructions for use

Loading ...

If necessary, remove coee deposits with the brush (C5)

supplied.

12.9 Cleaning the infuser

The infuser (A11) must be cleaned at least once a month.

Important!

The infuser may not be extracted when the machine is on.

1. Make sure the machine is correctly turned o (see “6. Turn-

ing the appliance o”);

2. Remove the water tank (A9);

3. Open the infuser door (A10) (g. 29) on the right side of

the appliance (g. 29);

4. Press the two coloured release buttons inwards and at the

same time pull the infuser outwards (g. 30);

5. Soak the infuser in water for about 5 minutes, then rinse

under the tap;

Important!

RINSE WITH WATER ONLY

NO WASHING UP LIQUID  NO DISH WASHER

Clean the infuser without using washing up liquid as it

could be damaged.

6. Use the brush (C5) to remove any coee residues left in the

infuser housing, visible through the infuser door;

7. After cleaning, replace the infuser by sliding it onto the in-

ternal support, then push the PUSH symbol fully in until it

clicks into place;

Please note:

If the infuser is dicult to insert, before insertion, adapt it to the

right size by pressing the two levers (g. 31).

8. Once inserted, make sure the two coloured buttons have

snapped out;

9. Close the infuser door;

10. Put the water tank back.

12.10 Cleaning the milk container

Clean the milk container (D) each time you prepare milk as de-

scribed below:

1. Remove the lid (D2);

2. Remove the milk spout (D5) and intake tube (D4) (g. 32);

3. Turn the froth adjust-

ment dial (D1) anti-

clockwise to the "IN-

SERT" position (g. 33)

and pull o upwards;

4. Wash all the compo-

nents thoroughly with

hot water and mild

washing-up liquid. All

components are dish-

washer safe, placing

them in the top basket

of the dishwasher.

Make sure there are no milk residues on the hollow and

groove under the dial (g. 34). If necessary, scrape the

groove with a toothpick;

34 35

5. Rinse inside the froth adjustment dial seat with running

water (g. 35);

6. Check that the intake tube and milk spout are not clogged

with milk residues;

7. Replace the dial (in correspondence to the word "INSERT"),

spout and milk intake tube;

8. Place the lid back on the milk container (D3).

12.11 Cleaning the hot water/steam connection

nozzle

Each time you prepare milk, clean the connection nozzle (A12)

with a sponge to remove milk residues from the gaskets (g.

24).

13. DESCALING

Descale the machine when the message "DESCALE" ashes on

the display (B1).

Important!

• Before use, read the instructions and the labelling on the

descaler pack.

dicator protrudes from the cup tray (A16), the drip tray must

be emptied and cleaned otherwise the water may overow the

edge and damage the appliance, the surface it rests on or the

surrounding area.

To remove the drip tray:

1. Remove the drip tray and the coee grounds container

(A14) (g. 25);

2. Empty the drip tray and grounds container and wash them;

3. Check the red condensate tray (A15) and empty if

necessary;

4. Replace the drip tray and grounds container.

12.5 Cleaning the inside of the coee machine

Danger of electric shock!

Before cleaning internal parts, the machine must be turned o

(see section “6. Turning the appliance o”) and unplugged from

the mains power supply. Never immerse the coee machine in

water.

1. Check regularly (about once a month) that the inside of the

appliance (accessible after removing the drip tray (A18))

is not dirty. If necessary, remove coee deposits with the

brush (C5) supplied and a sponge;

2. Remove all the residues with a vacuum cleaner (g. 27).

12.6 Cleaning the water tank

1. Clean the water tank (A9) regularly (about once a month

and whenever you replace the water softener lter (C4) (if

provided)) with a damp cloth and a little mild washing up

liquid;

2. Remove the lter (C4) (if present) and rinse with running

water;

3. Replace the lter (if provided), ll the tank with fresh

water and replace the tank;

4. (Models with water softener lter only) Deliver about

100ml of water.

12.7 Cleaning the coee spouts

1. Clean the coee spouts (A13) regularly with a sponge or

cloth (g. 28A);

2. Check that the holes in the coee spouts are not blocked.

If necessary, remove coee deposits with a toothpick (g.

28B).

12.8 Cleaning the pre-ground coee funnel

Check regularly (about once a month ) that the pre-ground cof-

fee funnel (A6) is not blocked.

Loading ...

Instructions for use - Page 18