User Manual - Page 150

For 2009.5 308 SW BL DAG.

Loading ...
Loading ...
Loading ...
i
!
154
DRIVING
REAR PARKING SENSORS
System consisting of four proximity sen-
sors, located in the rear bumper.
This detects any obstacle (person, ve-
hicle, tree, gate, etc.) behind the vehicle,
except obstacles located just below the
bumper.
An object, such as a stake, a road-
works cone or any other similar
object may be detected at the be-
ginning of the manoeuvre, but may
no longer be detected when the
vehicle comes close to it.
The parking sensor system can-
not, in any circumstances, take
the place of the vigilance and re-
sponsibility of the driver.
Activation
The system is activated as soon as re-
verse gear is engaged, accompanied
by an audible signal. The proximity in-
formation is given by:
- an audible signal, which becomes
more rapid as the vehicle approaches
the obstacle.
- a graphic on the multifunction
screen, with blocks which become
increasingly closer to the vehicle.
When the distance between the rear of
the vehicle and the obstacle is less than
thirty centimetres, the audible signal be-
comes continuous and the "Danger" sym-
bol appears on the multifunction screen.
On completion of the manoeuvre, when
you exit reverse gear, the system be-
comes inactive.
Programming
You can activate or deactivate the
system by means of the multifunction
screen confi guration menu. The system
state is memorised when switching off
the ignition.
For more information on access to the
parking assistance menu, refer to ve-
hicle confi guration in the "Multifunction
screens" section corresponding to your
screen.
The system will be deactivated auto-
matically when towing a trailer or when
a bicycle carrier is tted (vehicle tted
with a towbar or bicycle carrier recom-
mended by PEUGEOT).
Operating faults
If there is an operating fault,
when reverse gear is engaged
this warning lamp comes on on
the instrument panel, accompa-
nied by an audible signal (short beep)
and a message on the multifunction
screen.
In bad or wintry weather, ensure that
the sensors are not covered with mud,
frost or snow.
Loading ...
Loading ...
Loading ...