Loading ...
Loading ...
Loading ...
EN
44
29 - Induction Cooktop Operation
Before using the cooktop for the first time
• All products are wiped clean with solvents at the factory to
remove any visible signs of dirt, oil, and grease which may
have remained from the manufacturing process.
• Clean your glass top before the first time you use it. A
thorough cleaning with a glass top cleaner is recommended.
It only takes a minute and puts a clean, shiny coating on the
glass top before its initial use.
• There may be a slight odour during the first several uses: this
is normal and will disappear.
• Optimum cooking result depends on the proper cookware
being selected and used.
• The cooking surface will hold the heat and remain hot over
20 minutes after the elements have been turned off.
• The glass ceramic cooking surface is a durable material
resistant to impact but not unbreakable if a pan or other
object is dropped on it.
• Do nor allow pans to boil dry. This can damage the pan,
element and /or cooktop.
• Do not slide cookware across cooking surface it may scratch
the glass
Power Sharing
One generator controls 2 elements, or two/three cooking
zones within a heating section share the power of one
generator. Power Sharing is activated when both elements in
the same cooking zone are activated and one element is set for
Boost (P). The element that is not set for Boost will change to a
lower power level. This is called Power Sharing: The latest set
cooking level has priority.
30”
INDUCTION
36”
Power management (for 36” model only)
The 36” range features a power limitation system.
In the unusual case where 4 or 5 inductors of the cooktop are
being used on high (L9 or Boost) and the oven is then also
turned on, the power is reduced automatically on the cooktop
in order to keep the total consumption of the range below 50A.
However, it is unlikely that this level of power will be needed
during daily cooking activities and this power limiting event
may never be encountered. When the demand falls below 50A
again full power capabilities will be restored to the cooktop.
48”
Power management system (for 48” models only)
Considering all the power consuming features of this
appliance, the theoretical potential cumulative power draw
could exceed the required circuit breaker rating of 50 amps.
We must stress that under normal expected daily usage, the
probability of this ever happening is exceptionally low. Such a
power draw would require that both ovens are operating and
all surface elements have been set to their maximum settings
Loading ...
Loading ...
Loading ...