Wild Badger Power WB26MTSE 26cc Weed Wacker Gas Powered, 4 in 1 String Trimmer, Wheeled Edger

Operator’s Manual - Page 28

For WB26MTSE. Also, The document are for others Wild Badger Power models: WBPMT26P

PDF File Manual, 36 pages, Read Online | Download pdf file

WB26MTSE photo
Loading ...
Loading ...
Loading ...
Working with straight shaft Edger Attachment
An arrow on the deflector shows the correct direction of rotation of the cutting blade. The arrow on the deflector
must always face away from you , so that cuttings and other debris will be diverted away from the machine and
your position.
Adjust carrying harness and grip to suit your size before starting work . The machine should be properly balanced
as specified in your instruction manual for proper control and less fatigue in operation . To be better prepared in
c
ase of an emergency , practise releasing the unit from the harness as quickly as possible
Adjust the depth of cut by above knob, when it goes up, the wheel heightwould be low, when it goes down, the
wheel heightwould high. Shut off the engine-risk of accident
Note: The guard board under the knob can help you to go along the edge, if don’t need it, you can move it up.
The depth of cut is influenced by uneven ground as well as height and working position of the operator . For this
reason
-Adjust the wheel so that the bl
ade barely touches the ground when the machine is held in a normal working
posture or penetrates the ground at most toadepth (B) of 5 mm
Tighten the knob clockwise
Standing in the normal working position , check the depth of cut again - correct it if necessary
ATTENTION : when working on flat ground , adjust the alignment guide board (3 ) to be short ,and when working
on road side with gap, adjust the alignment guide board ( E3 ) to be longer and fitable for the road gap.
Warning ! Do not adjust the deflecto
r
The deflector has been set by the manufacturer so that the arrow on the deflector and the open side point away
from the operator . This ensures that cuttings and other debris will be directed away from the machine and
operator
Edging
-Start the engine

Loading ...
Loading ...
Loading ...