Loading ...
Loading ...
Loading ...
Pole saw:
Filling Chain Oil Tank
A full chain oil tank is sufficient for only half a tankful of fuel. Check the oil level regularly during
cutting work. Never allow the oil tank to run dry!
Thoroughly clean the filler cap and area around it so that no dirt can fall into the tank.
Position the unit so that the filler cap faces up.
If the oil level in the tank does not go down, the reason may be a problem in the oil supply system:
Check chain lubrication, clean the oil ways, contact your servicing deal-er for assistance if
necessary.
Checking Chain Lubrication
The saw chain must always throw off a small amountofoil.
Always check chain lubrication and the oil level in the tank before starting work.
Never operate your pruner withoutchain lubrication. If the chain is run dry, the whole cutting
attachment will be irretrievably damaged within a very short time.
Every newchain has to be broken in for about2to3minutes. After breaking in the chain, check
chain tension and adjust if necessary – see chapter „Checking Chain Tension“.
Adjusting the carry strap
PLEASE NOTE:This carry strap has a safety device allowing you to immediately disconnect the
strap from the machine in an emergency. To do so, pull forcefully on the red pull tab on the strap.
This disconnects the strap from the holding fixture immediately.
Loading ...
Loading ...
Loading ...