Loading ...
Loading ...
Loading ...
Lubricating the blade during use
If the cutting unit gets too hot during operation, the internalfaces of the blademust be
lubricated using a specific oil.
Please note: This procedure may only be carried outwhen the motor is switche
d off and the
blade has come toastop.
Blade drive housing
Lubricate at intervals of 20 hours via the lubricating nipple.
Use lithium-based lubricating grease for high temperatures and pressure value
s to lubricate
your machine.
Maintaining and sharpening the blade
Please note:Check regularly to ensure that the blades are not warped or damaged
andthat the
blade bed is in goodcondition.
The bladespacing does not have to be set, this tolerance is preset in the factory.
If the blades are used in accordance with the instructions, no maintenance or sharpeni
ng is
required.
Re-sharpening is only necessary if the cutting performance deteriorates and branches
often
become entangled.
Important:Shoulditberequired, any work on the blade must be carried out by a specia
lized center,
which hasspecialized equipment at its disposal and is in a position to perform the nece
ssary work
without negatively affecting the safety of the machine.
1. Mounting the rod:
Adjusting the carry strap
Loading ...
Loading ...
Loading ...