Loading ...
Loading ...
Loading ...
Chapter 5 To Trigger the Oscilloscope RIGOL
MSO5000-E User Guide 5-17
Pattern Trigger
Identifies a trigger condition by searching for a specif ied pattern. This pattern is a
logical "AND" combination of channels. Each channel can be set to H (high), L (low),
or X (don't care). A rising or falling edge (you can only specify a single edge) can be
specif ied for one channel included in the pattern. When an edge is specif ied, the
oscilloscope will trigger at the edge specif ied if the pattern set for the other channels
are true (namely the actual pattern of the channel is the same as the preset pattern).
I f no edge is specif ied, the oscilloscope will trigger on the last edge that makes the
pattern true. I f all the channels in the pattern are set to "X", the oscilloscope will not
trigg e r.
…
L
H
(CH1-CH2 or D0-D15)
…
(CH1-CH2 or D0-D15)
Figure 5-5 Pattern Trigger
Trigger Type:
Press Type, and then rotate the multifunction knob to select "Pattern". Press
down the knob to select the trigger type. Then, the current trigger setting
information is displayed at the upper-right corner of the screen, as shown in the
f igure below. You can also press Type continuously to select the trigger type or
enable the touch screen to tap the desired trigger type and select it.
Source Selection:
Press Source to open the signal source list and select CH1-CH2 or D0-D15. For
details, refer to descriptions in "
Trigger Source". The current trigger source is
displayed at the upper-right corner of the screen.
Note: Only when we select the channel (that has been input with signals) as the
Tip
For a better observation of the waveform details in the video signal, you can
set a larger memory depth f irst.
In the trigger debugging process of video signals, the frequency in different
part of the signal can be reflected by a different brightness, as RIGOL digital
oscilloscope provides the intensity graded color display function. Experienced
users can quickly judge the signal quality and discover abnormalities during
the debugging process.
Loading ...
Loading ...
Loading ...