Rigol MSO5152-E Rigol MSO5000E manual

Loading ...

RIGOL Chapter 17 Function/ Arbitrary Waveform Generator (Option)

17-2 MSO5000-E User Guide

To Output Basic Waveforms

Press Gen on the front panel or enable the touch screen to tap the GI label at the

bottom of the screen to enable/disable the output of the [ Gen] connector on the

front panel, and enter the Function/ Arbitrary Waveform Generator setting interface.

MSO5000-E series' built-in Function/ Arbitrary Waveform Generator can output a

variety of basic waveforms, including Sine, Square, Ramp, Pulse, DC, Noise, Sinc,

Exp.Rise, Exp.Fall, ECG, Gauss, Lorentz, Haversine, and Arb.

To Output Sine

Press Wave, rotate the multifunction knob to select "Sine". Press down the

knob to select it. You can also press Wave continuously or enable the touch screen

to select it. At this time, you can set the parameters for the sine waveform.

1. Set the frequency or period

First select Frequency or Period, then rotate the multifunction knob to

select "Frequency" or "Period". You can also press Frequency or Period

continuously to select it. Also, you can enable the touch screen to select it.

Rotate the multifunction knob

or use the pop-up numeric keypad to set the

frequency or period value of the current signal. Different waveforms have

different frequency or period (reciprocal of the frequency) ranges.

Sine: 100 mHz to 25 MHz

Square: 100 mHz to 15 MHz

Ramp: 100 mHz to 100 kHz

Pulse: 100 mHz to 1 MHz

DC and Noise: no frequency parameter.

2. Set the amplitude or high level

First select Amplitude or High Level, then rotate the multifunction knob to

select "Amplitude" or "High Level". You can also press Amplitude or High

Level continuously to select it. Also, you can enable the touch screen to select it.

Rotate the multifunction knob

or use the pop-up numeric keypad to set the

amplitude or high level value of the current signal. Note that if you select

"Amplitude" for this menu, then the menu below the Amplitude is automatically

turns out to be "Offset"; if you select "High Level" for this menu, then the menu

below the High Level is automatically turns out to be "Low Level". When

I mpedance is set to "HighZ", the available range is from 20 mVpp to 5 Vpp; when

I mpedance is set to "50Ω", the available range is from 10 mVpp to 2.5 Vpp.

3. Set the offset or low level

First select Offset or Low Level, then rotate the multifunction knob to

select "Offset" or "Low Level". You can also press Offset or Low Level

Loading ...

Rigol MSO5152-E oscilloscope