Loading ...
Loading ...
Loading ...
RIGOL Chapter 5 To Trigger the Oscilloscope
5-54 MSO5000-E User Guide
Figure 5-24 Trigger Output Connector
Press Utility System AUX Out to select "TrigOut”. A signal which reflects the
current capture rate of the oscilloscope can be output from the [ TRI G OUT]
connector each time a trigger is generated by the oscilloscope. I f this signal is
connected to a waveform display device to measure the frequency, the measurement
result is the same as the current capture rate.
Note: If you press Utility Syst em AUX Out to select "PassFail", then in the
pass/ fail test, when a pass/ fail event is detected, the oscilloscope outputs a pulse
from the rear-panel [ TRI G OUT] connector.
Trigger Output Connector
Loading ...
Loading ...
Loading ...