Loading ...
Loading ...
Loading ...
2271A
Operators Manual
52
Note
Modify the values in Auto Fill menu and applied Auto Fill would
change all setting values in test sequence.
Measure Setup
This menu has options and parameters for pressure measurement. See the
Measurement Setup section for detailed information on each menu item.
Each separated program name keeps a unique configuration of the Measure
Setup.
Control Setup
This menu has options and parameters for pressure control. See the Control
Setup section for detailed information on each menu item.
Each separate program name keeps a unique configuration of the Control Setup.
Run a Transmitter mA Program
To run a transmitter mA program:
1. When mA program configuration is ready, push to start the test. As the
test runs, the Product controls the pressure to the setpoint. Once at the
setpoint and the pressure stabilizes (Ready is shown), the dwell countdown
timer starts. Once the dwell is finished, if closed loop was ON, then the
measurement is taken and the Product continues to the next setpoint. If
closed loop is OFF, push continue to go to the next setpoint.
2. After the Run step finishes, a simple test result is shown on display. Push
page up or page down if it has multiple pages.
3. A test report file XXXX(DATE)_XXXX(TIME).csv is stored in the internal mass
storage disk. Use a USB cable connected to the chassis to copy the data
report.
Pressure Device
Before a pressure program is run to do an As Found or As Left test:
1. Prior to the test, do a leak test on the transmitter to make sure there are no
significant leaks. See the Leak Test section.
2. Connect the pressure device to one of the pressure ports. Make sure to plug
the other test port that is not in use.
3. Push on the front panel and select Pressure Device.
The pressure program menu is explained below:
1.888.610.7664 sales@GlobalTestSupply.com
Fluke-Direct.com
Loading ...
Loading ...
Loading ...