Loading ...
Loading ...
Loading ...
76 / 99
Table 14-1 Condition Setting
Function
Option
Description
Stop Type
Pass Count
Set the Pass/Fail function to stop the test automatically after
it reaches the specified threshold count of pass
Fail Count
Set the Pass/Fail function to stop the test automatically after
it reaches the specified threshold count of failure
Condition
＞=, ＜=
Set the stop condition
Threshold
Adjusting Multipurpose knob to set the threshold of stop condition
(6) Template Setting
Template setting is to set the template of pass/fail test. CH1 is used as the reference waveform to
create a template by default. If the waveform is within the template range, then the output is
successful. If the waveform exceeds the template range, then the output is failed.
Table 14-2 Template Setting
Function
Option
Description
Reference
Waveform
CH1, CH2
Specify a channel waveform in CH1~CH2 and plus the horizontal
and vertical tolerance as the conditions for creating a template
Horizontal
1~100
Adjusting Multipurpose knob to select the range of horizontal tolerance，
the default value is 5
Vertical
1~100
Adjusting Multipurpose knob to select the range of vertical tolerance，the
default value is 5
13.4 Web Access
(1) Access Local Area Network
The computer and the oscilloscope are under the same LAN. Check the IP address through the
UTILITY menu of the oscilloscope, and then the browser accesses the oscilloscope by IP: 9000 port.
Example:
Computer IP: 192.168.42.3
Oscilloscope IP: 192.168.42.12
PC browser using 192.168.42.12:9000 to access the oscilloscope
View the basic information, as shown in Figure 13-1.
Loading ...
Loading ...
Loading ...