Loading ...
Loading ...
Loading ...
55 / 99
(9) Error Setting
It can be set when trigger condition is “error”, it can set synchronization, ID parity check and
checksum.
a. Synchronization: synchronizing error
b. ID parity check: ID parity check error
c. Checksum: data check and error
(10) Setup Data Length
Set whether display the setting menu of the data length, it can set yes or no. when “yes” is selected,
the data length menu will be displayed, select “no”, the data length menu will not display.
(11) Data Length
Set the data length of LIN, which can set to 1~8, it is valid only setup data length is “yes”.
7.19 DECODE
DECODE button can set protocol decoding bus, such as bus status, display format, event list and position.
a. Bus Status: set decoding bus to on or off
b. Display Format: set the display format of decoding format, which can set to hexadecimal, decimal,
binary and ASCII.
c. Event List: the decoded data on the data line, the corresponding line number, time, data and parity
data will display in the format of a table, it’s helpful to observe the longer decoded data.
d. Vertical Position: Change the display position of bus by adjusting Multipurpose knob, which can set to
-160 ~ 160.
e. Trigger Setting: it can jump to trigger menu
Note: For I
2
C trigger, if there are signs READ and WRITE in the bus decoded data, the abbreviated R
and W are used in the bus instead.
Loading ...
Loading ...
Loading ...