Loading ...
Loading ...
Loading ...
75 / 99
(5) Quick Recording
It can continuous to record for improving capture waveform rate; waveform will not display on the
screen when perform quick recording; it can be played only the record is finished. It can set to on or
off.
13.3 Pass/Fail Test
Pass/Fail can set the template and judgment condition to perform Pass/Fail test, which can set allow
to test, output, information source, operating, template and stop setting.
The Pass/Fail uses a template to detect whether the input signal within the range of the template
requirements. If the input signal exceeds the limited range of the template, it is judged as failed.
(1) Allow to test
Allow to test is to select whether perform test or not. On: turn on to set and perform the test; off: turn
off is not allow to perform the test.
Total Wfs presents the total frame number that has tested
Pass Wfs presents the frame number that has passed
Fail Wfs presents the frame number that has failed
(2) Output
Set which signal output by AUX port, which can set to pass or fail.
a. Fail：Set the AUX port on the back panel of the oscilloscope to output pulse when “fail” and
produce beeps.
b. Pass：Set the AUX port on the back panel of the oscilloscope to output pulses when “pass”
and produce beeps.
Note: AUX output selection needs to be switched to Pass test.
(3) Information Source
Information source is the source pass through the test, which can set to
CH1, CH2.
(4) Operating Test
After the testing template, stop setting, source setting are completed, then to set “operating”. On:
performing the pass test. Off: turn off the pass test.
(5) Stop Setting
Stop setting is to set the stop conditions for pass/fail test, and automatically stop the test when the
conditions are met.
Loading ...
Loading ...
Loading ...