Hikvision DS-K1T343EX User Manual

Loading ...

By default, DHCP is enable. The system will allocate the IP address, the subnet mask, and the

gateway automacally.

If disable DHCP, you should enter the IP address, the subnet mask, and the gateway manually.

Tap OK to save the sengs and go back to the Wi-Fi tab.

Tap

to save the network parameters.

7.2.3 Set RS-485 Parameters

The face recognion terminal can connect external access controller, secure door control unit or

card reader via the RS-485 terminal.

Steps

Tap Comm. (Communicaon Sengs) on the Home page to enter the Communicaon Sengs

page.

On the Communicaon Sengs page, tap RS-485 to enter the RS-485 tab.

Figure 7-6 Set RS-485 Parameters

Select an peripheral type according to your actual needs.

Note

If you select Access Controller: If connect the device to a terminal via the RS-485 interface, set

the RS-485 address as 2. If you connect the device to a controller, set the RS-485 address

according to the door No.

Tap the back icon at the upper le corner and you should reboot the device if you change the

parameters.

DS-K1T343 Series Face Recognion Terminal User Manual

Loading ...

Hikvision DS-K1T343EX Value Series Face Access Terminal