Hikvision DS-K1T343EX User Manual

Loading ...

Note

●

The displayed parameters may vary for dierent access control devices. There are part of

parameters listed as follows. Refer to the user manual of the device for more details.

●

Some of the following parameters are not listed in the Basic Informaon page, click More to

edit the parameters.

Name

Edit the card reader name as desired.

OK LED Polarity/Error LED Polarity/Buzzer Polarity

Set OK LED Polarity/Error LED Polarity/Buzzer LED Polarity of main board according to the

card reader parameters. Generally, adopts the default sengs.

Minimum Card Swiping Interval

If the interval between card swiping of the same card is less than the set value, the card

swiping is invalid. You can set it as 0 to 255.

Max. Interval When Entering PWD

When you inpung the password on the card reader, if the interval between pressing two

digits is larger than the set value, the digits you pressed before will be cleared automacally.

Alarm of Max. Failed Aempts

Enable to report alarm when the card reading aempts reach the set value.

Max. Times of Card Failure

Set the max. failure aempts of reading card.

Tampering Detecon

Enable the an-tamper detecon for the card reader.

Communicate with Controller Every

When the access control device cannot connect with the card reader for longer than the set

me, the card reader will turn oine automacally.

Buzzing Time

Set the card reader buzzing me. The available me ranges from 0 to 5,999s. 0 represents

connuous buzzing.

Card Reader Type/Card Reader Descripon

Get card reader type and descripon. They are read-only.

Fingerprint Recognion Level

Select the ngerprint recognion level in the drop-down list.

Default Card Reader Authencaon Mode

View the default card reader authencaon mode.

Fingerprint Capacity

DS-K1T343 Series Face Recognion Terminal User Manual

145

Loading ...

Hikvision DS-K1T343EX Value Series Face Access Terminal